Use ERCF extruder to help the main extruder #174
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Update if statements to use new statuses
Only complain about being paused if its actually paused
Fix pause check
Fix name of reactor in heater timeout
* add logging * reduce long move by actual read move amount vs requested
Remove sync move until we figure out the problem
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
I would like to use the ERCF Gear has secondary extruder motor to help the filament to go through the tube... My tube is a 2.5mm but it's long my setup is not the best for a small tube ... It would be nice to use the current ercf extruder to help the main extruder with the filament.
Bah I just see another pull of that: #120
But there is no developpment on it
Thx