final fixes

Author: g-castronovo

content/hardware/08.edu/solution-and-kits/alvik/tutorials/getting-started/getting-started.md

@@ -19,10 +19,6 @@ Alvik's battery is protected by a pull-tab protective sticker. Remove the sticke
 
 ![Alvik pull tab](assets/Alvik-battery-pull-tab.jpg)
 
-**Step 1**: Locate the **pull-tab protective sticker** on the bottom of the robot, near the battery compartment. Grasp the tab and pull it upward firmly to remove the insulator and enable the battery connection.
-
-**Step 2**: After the pull-tab is removed, turn the robot over and slide the power button to ensure it powers on.
-
 Once the firmware of your Alvik is up to date and before start playing with it, let's verify your battery works as it should by following these steps:
 
 1. Makes sure Alvik is OFF and disconnected it from the PC.

content/hardware/08.edu/solution-and-kits/alvik/tutorials/user-manual/user-manual.md

@@ -113,7 +113,7 @@ Alvik's battery is protected by a pull-tab protective sticker. Remove the sticke
 
 **Step 1**: Locate the **pull-tab protective sticker** on the bottom of the robot, near the battery compartment. Grasp the tab and pull it upward firmly to remove the insulator and enable the battery connection.
 
-**Step 2**: After the pull-tab is removed, turn the robot over and slide the power button to ensure it powers on.
+**Step 2**: After the pull-tab is removed, turn the robot over, connect the robot to your computer and slide the power button to ensure it powers on.
 
 The battery is a rechargeable Li-ion 18650, it allows to run Alvik for 8+ hours non stop.