Update defconfig.esp32p4

Author: Jason2866

configs/defconfig.esp32p4

@@ -1,9 +1,35 @@
 CONFIG_IDF_EXPERIMENTAL_FEATURES=y
-CONFIG_SPIRAM=y
-CONFIG_SPIRAM_SPEED_200M=y
+
+# Enable LP Core
+CONFIG_ULP_COPROC_ENABLED=y
+CONFIG_ULP_COPROC_TYPE_LP_CORE=y
+CONFIG_ULP_COPROC_RESERVE_MEM=8192
+
+CONFIG_ESP_DEFAULT_CPU_FREQ_MHZ_360=y
+CONFIG_COMPILER_ORPHAN_SECTIONS_PLACE=y
 # CONFIG_ESP_TASK_WDT_CHECK_IDLE_TASK_CPU1 is not set
 CONFIG_LWIP_TCP_SACK_OUT=y
 
+CONFIG_SPIRAM=y
+CONFIG_SPIRAM_SPEED_200M=y
+CONFIG_SPIRAM_XIP_FROM_PSRAM=y
+CONFIG_SPIRAM_ALLOW_BSS_SEG_EXTERNAL_MEMORY=y
+CONFIG_SPIRAM_ALLOW_NOINIT_SEG_EXTERNAL_MEMORY=y
+CONFIG_SPIRAM_BOOT_HW_INIT=y
+CONFIG_SPIRAM_BOOT_INIT=y
+CONFIG_SPIRAM_PRE_CONFIGURE_MEMORY_PROTECTION=y
+
+CONFIG_RTC_CLK_CAL_CYCLES=576
+# CONFIG_ESP_SLEEP_GPIO_RESET_WORKAROUND is not set
+CONFIG_FREERTOS_WATCHPOINT_END_OF_STACK=y
+CONFIG_FREERTOS_TIMER_TASK_STACK_DEPTH=3120
+CONFIG_CACHE_L2_CACHE_256KB=y
+CONFIG_CACHE_L2_CACHE_LINE_128B=y
+
+# RGB Display Optimizations
+CONFIG_LCD_RGB_ISR_IRAM_SAFE=y
+CONFIG_LCD_RGB_RESTART_IN_VSYNC=y
+
 CONFIG_SLAVE_IDF_TARGET_ESP32C6=y
 CONFIG_ESP_SDIO_BUS_WIDTH=4
 CONFIG_ESP_SDIO_CLOCK_FREQ_KHZ=40000
@@ -15,17 +41,37 @@ CONFIG_ESP_SDIO_PIN_D2=16
 CONFIG_ESP_SDIO_PIN_D3=17
 
 #
-# RGB Display Optimizations
+# BT config
 #
-CONFIG_LCD_RGB_ISR_IRAM_SAFE=y
-CONFIG_LCD_RGB_RESTART_IN_VSYNC=y
+CONFIG_BT_ENABLED=y
+CONFIG_BT_CONTROLLER_DISABLED=y
+CONFIG_BT_BLUEDROID_ENABLED=n
+CONFIG_BT_NIMBLE_ENABLED=y
+CONFIG_BT_NIMBLE_TRANSPORT_UART=n
 
 #
 # Wi-Fi Remote
 #
 CONFIG_ESP_WIFI_REMOTE_ENABLED=y
 CONFIG_ESP_WIFI_REMOTE_LIBRARY_HOSTED=y
 
+#### Add Wi-Fi Remote config for better performance:
+CONFIG_ESP_WIFI_STATIC_RX_BUFFER_NUM=16
+CONFIG_ESP_WIFI_DYNAMIC_RX_BUFFER_NUM=64
+CONFIG_ESP_WIFI_DYNAMIC_TX_BUFFER_NUM=64
+CONFIG_ESP_WIFI_AMPDU_TX_ENABLED=y
+CONFIG_ESP_WIFI_TX_BA_WIN=32
+CONFIG_ESP_WIFI_AMPDU_RX_ENABLED=y
+CONFIG_ESP_WIFI_RX_BA_WIN=32
+
+CONFIG_LWIP_TCP_SND_BUF_DEFAULT=65534
+CONFIG_LWIP_TCP_WND_DEFAULT=65534
+CONFIG_LWIP_TCP_RECVMBOX_SIZE=64
+CONFIG_LWIP_UDP_RECVMBOX_SIZE=64
+CONFIG_LWIP_TCPIP_RECVMBOX_SIZE=64
+
+CONFIG_LWIP_TCP_SACK_OUT=y
+
 #
 # Enable ESP Hosted BT
 # Used as VHCI transport between BT Host and Controller
@@ -34,10 +80,9 @@ CONFIG_ESP_HOSTED_ENABLE_BT_NIMBLE=y
 CONFIG_ESP_HOSTED_NIMBLE_HCI_VHCI=y
 
 #
-# BT config
+# PPP
 #
-CONFIG_BT_ENABLED=y
-CONFIG_BT_CONTROLLER_DISABLED=y
-CONFIG_BT_BLUEDROID_ENABLED=n
-CONFIG_BT_NIMBLE_ENABLED=y
-CONFIG_BT_NIMBLE_TRANSPORT_UART=n
+CONFIG_LWIP_PPP_SUPPORT=y
+CONFIG_LWIP_PPP_NOTIFY_PHASE_SUPPORT=y
+CONFIG_LWIP_PPP_PAP_SUPPORT=y
+CONFIG_LWIP_PPP_ENABLE_IPV6=n