-
Notifications
You must be signed in to change notification settings - Fork 2
TPG26x
John Holt edited this page Jul 26, 2016
·
6 revisions
The TPG26x is shorthand for multiple devices with the same interface. They all measure pressure based on sensors that are plugged in. See https://www.pfeiffer-vacuum.com/en/products/measurement/activeline/controllers/?detailPdoId=5724 manual is also in C:\LabVIEW Modules\Drivers\Pfeiffer TPG26x\Documentation.
Simulator PVs are:
| Name | Description |
|---|---|
| SIM | 1 to switch simulation on, 0 off |
| SIM:UNITS | 1-3 for the different units |
| SIM:X:PRESSURE | To set the pressure readback (X is 1 or 2) |
| SIM:X:ERROR | To set the error, 0 - 6; 0 is no error (X is 1 or 2) |
Set up the port with in the st.cmd and run the simulator. There are several backdoor command to set the internal state, telnet to the emulator and then issue:
| Command | Arguement | Description |
|---|---|---|
| emulator:set:pressureX | Set the pressure of sensor X (X 1 or 2) | |
| emulator:set:errorX | <error 0-6> | Set the error of sensor X (X 1 or 2) |
| emulator:set:units | <error 1-3> | Set the units |